Study on the Factors Affecting the Stability of Drainage Foam in Coastal Power Plants and the Aeration Pattern of the Overflow Weir

Coastal power plants draw seawater from the open ocean through their cooling-water circulation systems. The cooling water falls over an overflow weir inside the siphon well, entraining large quantities of air, and generates a foam pollution plume upon discharge to the sea. By combining physical model experiments with numerical simulation, this study investigates the key factors governing foam stability and the aeration behavior of the water downstream of the siphon-well overflow weir. The principal conclusions are as follows: among the three single-factor variables tested in controlled laboratory conditions—temperature, salinity, and shellfish-flesh suspension concentration—the biological substance proxy showed the strongest effect on foam stability; when the shellfish-flesh suspension concentration reaches 20% (mass/volume basis, independently prepared), the foam volume and half-life increase by factors of 1.4 and 3.36, respectively, relative to the 4% baseline condition. When the dimensionless aeration depth z/z90 < 0.75, the air-concentration profile rises relatively slowly with depth, whereas it increases more rapidly as the free surface is approached. Within the investigated viscosity range of 1.0–8.3 mPa·s (1.0 mPa·s for the pure-water control and 1.5–8.3 mPa·s for the measured viscosities of the 4–20% shellfish-flesh suspensions), the cross-sectional mean air concentration shows an overall decreasing trend as the liquid-phase viscosity increases, and the total bubble number density decreases correspondingly. The findings provide a laboratory-based indication of the mechanisms that must be addressed in the development of physical foam-suppression technologies; confirmation against field discharge water is required.