Numerical and Experimental Ground Vibration Test of Composite Flying Wing

Ground vibration testing (GVT) plays a key role in the validation of numerical models and the assessment of aeroelastic stability in lightweight aircraft structures. This study presents an experimental and numerical investigation of a full-scale composite flying wing unmanned aerial vehicle (UAV) intended for vertical take-off and landing operations. Due to its low structural mass and highly integrated configuration, the aircraft exhibits increased sensitivity to modeling assumptions, boundary conditions, and measurement uncertainties. A finite element model was developed in Ansys, incorporating detailed laminate definitions and the internal sandwich structure. Experimental modal testing was performed under free-free boundary conditions using an electrodynamic shaker and a distributed measurement consisting of 94 response locations. Frequency Response Functions (FRFs), coherence analysis, and the Complex Mode Indication Function (CMIF) were employed to identify the dominant structural modes. Particular attention was given to the bending and torsional modes that govern aeroelastic behavior. Comparison of experimental and numerical results showed good agreement in mode shapes, while discrepancies in natural frequencies ranged from 10.4% to 20.1%. The results demonstrate that the model adequately captures the dynamic behavior of the aircraft and provides a reliable basis for future aeroelastic and flutter analyses of lightweight composite flying wing.