Multiphysics Analysis and Optimization of a Thin-Film Lithium Niobate Phase Modulator for Fiber-Optic Gyroscopes

Lithium niobate on insulator (LNOI) has emerged as a promising platform for compact, low-loss phase modulators. The extant LNOI studies evaluate device performance almost exclusively through the Pockels effect, treating piezoelectric–photoelastic strain and thermo-optic drift as decoupled channels. Crucially, both mechanisms directly perturb the phase bias of a fiber-optic gyroscope (FOG), rendering them indispensable in sensing-oriented design. This work establishes a unified multiphysics model of an X-cut TFLN ridge phase modulator that self-consistently couples the electro-optic, piezoelectric–photoelastic, thermo-optic, and pyroelectric channels. The contributions of the four mechanisms are quantitatively decomposed under realistic FOG operating conditions, and the slab thickness, ridge-top width, and electrode gap are systematically optimized to balance modulation efficiency against environmental robustness. The co-optimization of the ridge geometry and electrode gap design maintains the EO overlap factor near 0.55, while reducing the half-wave voltage requirement. This results in a half-wave voltage length of VπL = 1.65 V·cm at a 4.4 μm electrode gap. The optimized geometry and electrode gap (4.4 μm) are essentially temperature-independent: extracted from the Pockels modulation slope, VπL remains stable at ≈1.65 V·cm (push–pull single-pass; within ~0.3%) across 25~85 °C. Furthermore, an externally imposed substrate temperature rise of 60 K (the upper end of the 25~85 °C FOG operating range) induces a mode-field-weighted thermal residual corresponding to approximately 27% of the Pockels modulation depth at an applied voltage of 5 V. The present study demonstrates that the DC-coupled operation of TFLN sensor-grade modulators is viable across the full FOG temperature range, without dedicated active temperature stabilization, and the residual thermal-bias offset is absorbed by the FOG’s standard closed-loop servo electronics. The results of the study provide quantitative design guidelines for high-performance, environmentally stable TFLN phase modulators in compact FOG systems.