DOI: 10.1017/jfm.2026.11723 ISSN: 0022-1120
Low-wavenumber wall pressure fluctuations in turbulent flows within concentric annular ducts
Yaomin Zhao, Taiyang Wang, Benshuai Lyu
Compressible direct numerical simulations of turbulent channel flows in concentric annular ducts of height
2 delta
2
δ
$2\delta$
are performed to study the low-wavenumber wall pressure fluctuations (WPF) over cylindrical walls at bulk Mach number
upper M Subscript b Baseline equals 0.4
M
b
=
0.4
$M_b = 0.4$
and bulk Reynolds number
italic Re Subscript b Baseline equals 3000
Re
b
=
3000
${\textit{Re}}_b=3000$
. The radius of the inner cylinder
upper R
R
$R$
is varied between
0.2 delta
0.2
δ
$0.2\delta$
,
delta
δ
$\delta$
,
2 delta
2
δ
$2\delta$
and
normal infinity
∞
$\infty$
. As
upper R
R
$R$
decreases, the one-point power spectral density of the WPF decreases at intermediate frequencies but increases at high frequencies. When
upper R
R
$R$
decreases, the one-dimensional (streamwise) wavenumber–frequency spectrum of the WPF decreases at high wavenumbers. At low wavenumbers, however, as
upper R
R
$R$
reduces to
0.2 delta
0.2
δ
$0.2\delta$
, the one-dimensional wavenumber–frequency spectrum exhibits multiple spectral peaks whose strengths increase with frequency. Examination of the two-dimensional wavenumber–frequency spectra shows that these represent acoustic duct modes that closely match theoretical predictions. The acoustic modes of higher radial orders exhibit increasingly high amplitude on the inner walls rather than on the outer walls. The low-wavenumber components of the
0
0
$0$
th-order (azimuthal) two-dimensional wavenumber–frequency spectrum are of great importance in practice, and their magnitude increases as
upper R
R
$R$
reduces; this increase is increasingly pronounced at higher frequencies. Analytical modelling and numerical validation show that this increase appears to arise from the ‘geometric’ effects connected with the Green’s function, and they are generated mainly by radial and azimuthal disturbances. Disturbances closer to the wall are shown to be increasingly important in WPF generation as
upper R
R
$R$
reduces, which highlights a potential for WPF control using wall treatment on thin cylinders.