Integrated Geomechanical Coupled Model for Co-Production of Tight Gas and Deep CBM and Its Parameter Sensitivity Study

Coal-bearing tight gas and deep coalbed methane (CBM) widely co-occur in China, and integrated commingled production outperforms separate development. Conventional separated simulation fails to capture coupled reservoir–wellbore gas–water flow. This study develops an integrated geomechanical coupled numerical model with multi-scale fractures and multi-phase wellbore flow: tight gas reservoirs use a stress-sensitive single-porosity model, deep CBM adopts a dual-porosity model for matrix desorption, and EDFM characterizes non-Darcy flow in hydraulic fractures. The Gray gas column and liquid column methods calculate layered bottomhole pressure according to reservoir vertical distribution, and matrix bordering solves the whole coupled system. Validated by field data of Well C-1 in Shanxi, the model yields average relative errors of 8.76% for daily gas output and 2.92% for daily water output. Sensitivity analysis on Well C-2 indicates vertical reservoir stacking controls interlayer pressure difference, and commingled gas curves show dual peaks with shifting dominant gas sources over production stages. A 3.9% rise in deep coalbed methane gas content significantly boosts mid-term peak production and cumulative gas output, making reservoir gas content the dominant geological factor governing commingled production performance. A 120.0% increase in tight gas saturation only delivers a slight uplift in cumulative production under low-porosity conditions. Elevated reservoir stress sensitivity triggers a cumulative gas production reduction of over 50%. Cumulative gas output varies proportionally with hydraulic fracture length, while fracture network width brings mismatched production improvement due to pressure drawdown funnel effects. Therefore, hydraulic fracturing operations should prioritize extending artificial fractures to expand the drainage area of commingled wells. Schemes with constant bottomhole flowing pressure and constant gas rate exert marginal influences on ultimate cumulative production and can be flexibly switched on site. To stabilize daily gas deliverability throughout the early, middle and late production stages, a bottomhole pressure drawdown rate of 0.05 MPa/d or a fixed daily gas rate of 4000 m3/d is recommended. This work provides theoretical support for optimizing commingled development of superimposed tight gas and deep CBM reservoirs.