Dual-Mode Triboelectric and Capacitive Pressure Sensor Based on Anodic Aluminum Oxide

Triboelectric nanogenerators (TENG) show significant potential in pressure sensing by converting mechanical disturbances into electrical signals positively correlated with the magnitude of the applied force, yet their development as practical pressure sensors is severely hindered by the major drawback of only detecting transient mechanical inputs. Additionally, traditional dual-mode pressure sensors have typically required complex multilayer structures and time-consuming fabrication processes. Here, a simple dual-mode pressure sensor of novel structure integrated with TENG and anodic aluminum oxide (AAO) for both dynamic and static pressure detection is proposed. Nanoporous AAO is directly grown on an aluminum substrate to simplify the traditionally complex multi-layer structure of dual-mode pressure sensors. The AAO layer serves a dual functionality by acting as an active triboelectric layer that significantly enhances the triboelectric output performance while concurrently functioning as the capacitive dielectric layer. A polydimethylsiloxane (PDMS) film is employed as the elastic counterpart to pair with the AAO substrate. The influence of PDMS thickness on the charge accumulation and extraction of the TENG mode is investigated to optimize the device output. Under optimal configurations, the streamlined Al-AAO/PDMS sensor demonstrates good sensitivity and linearity (R2 > 0.99) for both dynamic triboelectric voltage (1.05 V/kPa) and static capacitance (5.56 pF/kPa) over a wide sensing range of 1–73 kPa. This dual-mode sensor effectively overcomes the transient limitation of conventional single-mode TENGs and shows significant potential for future smart tactile applications.