Dependence of Discharge Energy and Material Removal Dynamics on Tool Electrode–Workpiece Material Combinations in Electrical Discharge Machining

Electrical discharge machining (EDM) demonstrates significant advantages in machining difficult-to-cut materials, particularly those with high hardness and brittleness, owing to its thermally driven material removal mechanism in which the arc plasma serves as the heat source. However, machining performance varies markedly across different workpiece materials. Such differences are likely attributable to the coupled effects of arc plasma characteristics, which may vary with tool–workpiece material combinations, and the thermophysical properties of the workpiece. Nevertheless, the mechanisms underlying this coupling remain poorly understood. In this study, arc plasma characteristics and material removal behavior under different material combinations were investigated using arc plasma and thermo-hydrodynamic simulation models. Under positive polarity, a copper tool electrode was paired with 304 stainless steel, Ti-6Al-4V, and Inconel 718 workpieces, while copper and tungsten electrodes were compared using a 304 stainless steel workpiece. Simulation results show that material combinations significantly affect anode heat flux and energy distribution, with 304 stainless steel exhibiting the highest heat flux and Inconel 718 receiving the largest energy distribution ratio. Crater depth correlates strongly with heat flux magnitude, while crater diameter is jointly determined by heat flux radius and melt flow dynamics, with the selected cathode material exerting only minor influence. High-speed imaging and crater morphology measurements validate the simulation results, confirming model reliability. These findings provide theoretical guidance for process optimization in EDM.