Comparative Study of Laser and GMAW Technologies: Effects on Mechanical Strength and Salt Spray Corrosion Performance of SGH340D + ZMA Galvanized Automotive Steel

The aim of this work is to investigate the influence of different welding technologies on the mechanical properties and corrosion resistance of welded joints of SGH340D + ZMA steel with a Zn–Mg–Al (ZMA) protective coating. Two different welding technologies were used: the gas metal arc welding(GMAW) process at a welding speed of 0.8 m/min and laser welding at speeds of 2 and 4 m/min. Mechanical properties were determined using tensile testing and hardness testing. Corrosion resistance was estimated using a salt spray test. Residual stresses were determined experimentally using the drill hole method. The highest residual stresses were measured in GMAW-welded joints, while the lowest were measured in laser-welded joints at a speed of 4 m/min. The sample welded by laser at a speed of 4 m/min exhibited hardness values close to the upper acceptable limit, indicating that further increases in welding speed without preheating may lead to excessive hardness. All samples exhibited good corrosion resistance in a salt chamber. According to the results, increased welding speed reduced residual stresses but increased the risk of brittle fracture.